Optimization of MQL Parameters Using the Taguchi Method in Milling of Nickel Based Waspaloy

Basit Öğe Kaydı
dc.authoridSarikaya, Murat/0000-0001-6100-0731
dc.contributor.authorYildirim, Cagri Vakkas
dc.contributor.authorKivak, Turgay
dc.contributor.authorErzincanli, Fehmi
dc.contributor.authorUygur, Ilyas
dc.contributor.authorSarikaya, Murat
dc.date.accessioned2025-03-23T19:48:30Z
dc.date.available2025-03-23T19:48:30Z
dc.date.issued2017
dc.departmentSinop Üniversitesi
dc.description.abstractThis study aimed to investigate the effect of the minimum quantity lubrication (MQL) parameters such as cutting oil type, flow rate, milling method, pulverization distance and nozzle type on average surface roughness (Ra) in milling of nickel based Waspaloy super alloy. During milling experiments, constant cutting speed (45 m/min), feed rate (0.1 mm/rev) and depth of cut (0.5 mm) were selected as machining parameters. Four different types of oil (vegetable, synthetic, mineral and mineral-synthetic), four different flow rates (25, 50, 75 and 100 ml/h), two different milling methods (down milling and up milling) two pulverization distances (25 and 50 mm) and two different nozzle types were chosen as MQL parameters. The results were analyzed using 3D surface graphs, signal-to-noise ratio (S/N) and main effect graphs of means. Optimal MQL parameters were determined using the S/N ratio. Mathematical models have been created for surface roughness. The analysis results indicated that the dominant factors were oil type and flow ratio on surface roughness. In addition, confirmation test results showed that the Taguchi method was very successful in the optimization of MQL parameters in order to obtain minimum surface roughness in milling of Waspaloy super alloy.
dc.description.sponsorshipDuzce University Research Fund [2015.07.04.335]
dc.description.sponsorshipThis research was financially supported by Duzce University Research Fund, and Project Number: 2015.07.04.335.
dc.identifier.endpage186
dc.identifier.issn2147-1762
dc.identifier.issue2
dc.identifier.scopus2-s2.0-85021088259
dc.identifier.scopusqualityQ2
dc.identifier.startpage173
dc.identifier.urihttps://hdl.handle.net/11486/7604
dc.identifier.volume30
dc.identifier.wosWOS:000405869900013
dc.identifier.wosqualityN/A
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.language.isoen
dc.publisherGazi Univ
dc.relation.ispartofGazi University Journal of Science
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/closedAccess
dc.snmzKA_WOS_20250323
dc.subjectWaspaloy
dc.subjectMilling
dc.subjectMQL
dc.subjectSurface Roughness
dc.subjectOptimization
dc.titleOptimization of MQL Parameters Using the Taguchi Method in Milling of Nickel Based Waspaloy
dc.typeArticle

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu